|
The clutch control rope runs through a swivel on top of the winch.
The winch can therefore be operated from any direction. This is an
important feature for the operator as he can control the winch
from a place where he can see the load as he is pulling it in.
Good vision will enable the operator to prevent loads from hooking up
behind stumps and roots and also to reduce damage on the remaining
trees.
This feature also enhances operator safety and production.
Without leaving the tractor seat, one can release the load, drive out of
adverse conditions and winch the load in again. When winching from
the tractor seat, one must have the optional protective screen installed
between the winch and the operator. The clutch enables the
operator to select any pull from zero to maximum pull of the winch.
The clutch will slip when the load is heavier than the selected pull.
This prevents damage to the cable or winch even if the load gets hooked
behind a stump or root.
Both the clutch and the drum lock are rope controlled. The
operator can stand safely to the side, away from the cable and the logs.
The clutch pads are over 3/8" thick and riveted with 12 rivets.
The clutch is warranted for 5 years in everyday use. A new
clutch can be riveted on the old sprocket so the clutch is easy and
inexpensive to replace. The sturdy upper sprocket acts as a heat
sink and absorbs the heat generated in the clutch when winching, so the
clutch will not burn out.
Four logs can be winched in and skidded out hooked to the cable.
An additional eight logs can be hooked up and skidded out from the
notches on the winch frame.
The large, heavy-duty drum can house up to 265 feet of 3/8" cable.
This exceptional reach enables the JL 501 to be used also in very
difficult terrain.
The cable coils better due to the improved design of the winch drum.
Even coiling is further improved by the sensor roller which senses if
the cable is moving in or out. If, for example, the cable is
pulled out, the sensor releases the drum brake and it is very easy to
pull the cable. When the cable has been pulled out, the sensor
notes that the cable motion has stopped and engages the drum brake.
That stops the drum from turning and prevents backlash and tangle of the
cable on the drum.
The winch frame is 65" high. The high point of pull is very
beneficial as it creates down-pressure on the winch when winching.
The down-pressure pushes the blade into the ground which anchors the
winch and tractor in place. The frame is also "thin" so the winch
is close to the tractor. Large net loads can therefore be
skidded out as the weight is close to the tractor. ROPS cab,
and front end weights or front end loader is a must.
An unique Farmi feature is the adjustable snatchblock on the JL 501
model. The lower snachblock can be adjustable up or down on a rail
so optimal traction can be transferred to the rear wheels on different size tractors.
|
